Looking for INSTRUCTIONS ON INSTALLATION? Click below to download our PDF installation guides:

Manual Thumb Installation Instructions

Hydraulic Thumb Installation Instructions

Dozer Rake Installation Instructions

Bucket Fork Installation Instructions

Are you looking to purchase one of our thumbs and our salesman has requested you fill out our BUCKET SPEC SHEET? Click below to download:

Bucket/Coupler Spec Sheet
where are you located?
We are located 20 miles east of downtown Houston, Texas.

Physical Address
119 Listi Lane
Highlands, TX 77562

Mailing Address
PO Box 324
Highlands, TX 77562
do you OFFER SHIPPING, LOCAL DELIVERY, OR INSTALLATION? 
For an extra fee, we offer shipping on our products via LTL services (less than truckload) anywhere within the contiguous United States. In order to provide the best freight rate, each shipment is quoted on a case-by-case basis.

Local delivery and installation available upon request for an additional fee.

​Please call our office for more details.
WHERE CAN I FIND INSTALLATION INSTRUCTIONS?
How to: MEASURE for EXCAVATOR THUMB
Information we need from you:

MANUAL THUMB
  1. Make & model of machine
  2. Measurement of the tip radius. The tip radius is defined as the length from the center of the main pin to the tip of the teeth.
  3. If your machine has a quick coupler/pin grabber, measuring the tip radius is slightly different. With bucket attached to the coupler, you will need to measure the length from where the main pin goes through the stick to the tip of the teeth

HYDRAULIC THUMB
  1. Make & model of machine
  2. To provide a general estimate, the tip radius measurement is needed. Remember, if you have quick coupler/pin grabber, this is measured slightly different. See HOW TO: MEASURE TIP RADIUS.
  3. To ensure an exact and proper fit, we require a BUCKET SPEC SHEET to be completed. DOWNLOAD HERE
how to: MEASURE for dozer rake
What we need to know:
  1. Make & model of machine
  2. Width of the blade
  3. Shape of blade (straight or semi-u)
how to: measure for excavator rake
What we need to know:
  1. Make & model of machine
  2. Main pin diameter (MM)
HOW TO: Measure tip radius (for thumb)
If your machine has...

BUCKET ONLY: To provide an accurate tip radius of your bucket, measure from the end of the bucket teeth to the center of the main pin of the bucket

BUCKET WITH COUPLER: Tip radius can be determined by measuring from the end of the bucket teeth to the center of the main pin that goes through the end of the stick 

CONTACT US

Don't see the answer you are looking for? Please give our office a call (281) 843-5000 for further assistance.